The Checkpoint Coverage report allows Managers to review Checkpoint scans for a selected day and verify whether each scan was performed within or outside the configured Checkpoint range.
You can access it from:
Reports → Checkpoint Coverage
Filters
Use the filters at the top of the page to select the data you want to review.
The report can be filtered by:
- Date and Time
- Range Filter (All/In-range/Out of range)
- Branch Office
- Client
- Site
- Check Point
- Guard
The report displays data for one day at a time. Once the required filters have been selected, click Apply to load the results.
Results
The results are displayed in two complementary views:
On the left, the Map View provides a visual representation of the corresponding scans, showing the exact location where each scan was performed.
On the right, the Checkpoint Scans – Geofence Status table displays the same scan information in detail, including the Checkpoint, Guard, Geofence Status and Scan Time.
The map markers are displayed as follows:
- 🔵 Blue – Checkpoint: The configured location of the Checkpoint, based on the Latitude and Longitude defined in the Checkpoints page.
- 🟢 Green – In Range Scan: The GPS location reported by the Guard’s mobile device when the scan was performed. The system calculated that the scan was within the configured Checkpoint range.
- 🔴 Red – Out of Range Scan: The GPS location reported by the Guard’s mobile device when the scan was performed. The system calculated that the scan was outside the configured Checkpoint range.
This allows Managers to compare the configured Checkpoint location with the actual GPS location received from the mobile device at the time of the scan, both visually on the map and through the detailed table.
The report can also be exported to Excel or PDF.
